Question I've had many scopes in the past but never one like the EP5 where when zeroed you could loosen the turrets and zero them out. I did this but later repositioned the scope further back on the mount. When rezeroing the scope bottomed out and would not move far enough to the left to reach the zero. Any suggestion?
top of page
Log In to Connect With Members
View and follow other members, leave comments & more.
bottom of page
I have a similar problem. (ep5) 240 clicks total. Zero is at 120 clicks. I turn the turret out all the way and it still shoots to far left. It's close but I'm thinking optics are off. Can I reset that? Scope was working fine last time I used it. I did take the scope off and re-fit it in an attempt to realign it but still same results. Did I drop it? I don't think I did.. but really don't know.
Jim
We have seen this before when the turret wasn't centered from the factory. Count your total clicks of your windage, and then take that number and divide by 2. Take that number, and count back from either the left or right limit. Then slip the turret completely off and reinstall it to zero. Then zero your scope again, that should fix the issue. Let us know if that works out for you.